Installing The Switch With The At-Rkmt-J14 Brackets; Figure 21: Switch Orientations With The Rear Panel Facing The Front Of The Equipment Rack - Allied Telesis AT-x550-18XTQ Installation Manual

Installing the
Switch with the
AT-RKMT-J14
Brackets
You can also orient the switch with the rear panel facing the front of the
equipment rack. Refer to Figure 21.
Figure 21. Switch Orientations with the Rear Panel Facing the Front of the
If you have not chosen an orientation for the switch in the equipment rack,
review "Switch Orientations in the Equipment Rack" on page 59.
Please review the installation guidelines in "Choosing a Site for the Switch"
on page 50 before installing the switch in an equipment rack.
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack.  E28
To install the switch in a 19-inch equipment rack with the AT-RKMT-J14
Brackets, perform the following procedure:
1. Attach the two handles to the AT-RKMT-J14 Brackets using the four
M3x6mm screws included with the switch. Refer to Figure 22 on page
62.
x550 Series Installation Guide for Virtual Chassis Stacking
Equipment Rack
61