4. Connect the power cord to an appropriate AC power source. Refer to
Figure 43.
Figure 43. Connecting the Power Cord to an AC Power Source
Note
The illustration shows a North American power cord. Your power
cord may be different.
5. Wait two minutes for the switch to initialize its management software.
6. View the ID LED and do one of the following:
If the ID LED is displaying a number from 1 to 8 (1 is the default),
VCStack is already enabled on the switch. Continue with the next
step.
If the ID LED is displaying "0," the VCStack feature is disabled on
the switch. Perform the procedures "Starting a Local Management
Session" on page 91 and "Enabling the VCStack Feature" on
page 93 to enable it.
7. Power off the switch by disconnecting the power cord from the power
source. Refer to Figure 44 on page 90.
x550 Series Installation Guide for Virtual Chassis Stacking
89