Figure 35: Steps To Installing The Switch With A Plywood Base - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 5: Installing the Switch on a Wall
Wall Studs
Wall
76
inches) while the distance between the front and rear brackets on the
switch is 34.4 centimeters (13,6 inches). If you install the switch without
the base, only two brackets on the switch would be on a wall stud.
The recommended minimum dimensions of the plywood base are listed
here:
 Width: 55.9 centimeters (22 inches)
 Height:35.6 centimeters (14 inches)
 Thickness: 5.1 centimeters (2 inches)
The dimensions assume the wall studs are 41 centimeters (16 inches)
apart. You might need to adjust the width of the base if the distance
between the studs in your wall is different than the industry standard.
You should install the plywood base on the wall and then install the switch
on the base. Refer to Figure 35.
Step 1: Install the
plywood base on
the wall.
Figure 35. Steps to Installing the Switch with a Plywood Base
Plywood
Base
Step 2: Install the
switch on the
plywood base.