Figure 46: User Exec Mode Prompt - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 6: Verifying the Status of the Switches
92
You are prompted for a user name and password.
5. If this is the initial management session of the switch, enter "manager"
as the user name and "friend" as the password. The user name and
password are case sensitive.
The local management session starts when the User Exec mode
prompt, shown in Figure 46. is displayed.
awplus>
Figure 46. User Exec Mode Prompt
The User Exec mode is the first level in the command mode interface.
For complete information on the modes and commands, refer to the
Software Reference for x550 Series Switches, AlliedWare Plus
Operating System.
6. Do one of the following:

If you need to enable the VCStack feature on the switch, perform
the procedure in "Enabling the VCStack Feature" on page 93.
 If you want to confirm that this switch has the same version of
management software and feature licenses as the other switch, go
to "Comparing the AlliedWare Plus Version Numbers and Feature
Licenses" on page 95.
 Otherwise, go to Chapter 7, "Installing the Stacking QSFP+
Transceivers" on page 99