Installing The Switch On A Table Or Desktop - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 4: Installing the Switch on a Table or in an Equipment Rack

Installing the Switch on a Table or Desktop

56
This section contains the procedure for installing the switch on a table.
Note
The rubber feet on the bottom of the chassis should be left on for
table installation.
Warning
Switches should not be stacked on a table or desktop. They could
present a physical safety hazard if you need to move or replace
switches.  E91
To install the chassis on a table, perform the following procedure:
1. Review the procedure in Chapter 3, "Choosing a Site for the Switch"
on page 50to verify that the selected site is suitable for the unit.
2. Check to be sure that the table is strong enough to support the weight
of the switch.
3. Lift the chassis onto the table.
4. Check to be sure that all of the appropriate components are included
in the shipping container. Refer to "Unpacking the Switch" on page 51.
After placing the switch on the table or desktop, go to Chapter 6, "Verifying
the Status of the Switches" on page 85.