Forwarding Database Commands; Create Fdb; To Create A Unicast Mac Fdb Entry - D-Link DES-3010F Command Line Interface Reference Manual

Managed 8/16/24-port 10/100mbps n-way fast ethernet switch
Hide thumbs Also See for DES-3010F:
Table of Contents

Advertisement

The layer 2 forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

create fdb

create multicast_fdb
config multicast_fdb
config fdb aging_time
clear fdb
show multicast_fdb
show fdb
delete fdb
Each command is listed, in detail, in the following sections.
create fdb
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To create a unicast MAC FDB entry:

DES-30XX Layer 2 Switch CLI Reference Manual
F
Parameters
<vlan_name 32> <macaddr> port <port>
<vlan_name 32> <macaddr>
<vlan_name 32><macaddr> [add | delete] <portlist>
<sec 10-1000000>
[vlan <vlan_name 32> | port <port> | all]
{vlan <vlan_name 32> | mac_address <macaddr>}
{port <port> | vlan <vlan_name 32> | mac_address <macaddr> |
static | aging_time}
<vlan_name 32> <macaddr>
Used to create a static entry to the unicast MAC address forwarding
table (database)
create fdb <vlan_name 32> <macaddr> port <port>
This command will make an entry into the Switch's unicast MAC
address forwarding database.
<vlan_name 32> − The name of the VLAN on which the MAC
address resides.
<macaddr> − The MAC address that will be added to the forwarding
table.
port <port> − The port number corresponding to the MAC destination
address. The Switch will always forward traffic to the specified
device through this port.
Only administrator-level users can issue this command.
DES-3026:4#create fdb default 00-00-00-00-01-02 port 2
Command: create fdb default 00-00-00-00-01-02 port 2
Success.
DES-3026:4#
ORWARDING
74
D
C
ATABASE
11
OMMANDS

Advertisement

Table of Contents
loading

This manual is also suitable for:

3010g - des switchDes-3010gDes-3018Des-3026

Table of Contents