Download/Upload Commands; Download - D-Link DES-1210-28/ME Reference Manual

The Download/Upload commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

download

upload
Each command is listed in detail, as follows:
download
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To download a firmware file:
DES-1210-28/ME:5# download firmware 1.1.1.23 1\des_1210-28me.ros
Command: download firmware 1.1.1.23 1\des_1210-28me.ros
01–Jan–2000 01:19:48 %COPY–I–FILECPY: Files Copy – source URL tftp://1.1.1.23 /1\
des_1210-28me.ros destination URL Unit all flash://image
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide

DOWNLOAD/UPLOAD COMMANDS

Parameter
[configuration <ipaddr> <path_filename 64> startup] | [firmware <ipaddr> <string
64>]
[[firmware <ipaddr> <path_filename 64>] | [cfg_toTFTP <ipaddr> <path_filename
64> config_id <value 1-2>] | [log_toTFTP <ipaddr> <path_filename 64>]]
To download and install a firmware, boot, or switch configuration file
from a TFTP server.
download [configuration <ipaddr> <path_filename 64> startup] |
[firmware <ipaddr> <string 64>]
The download command downloads a firmware, boot, or switch
configuration file from a TFTP server.
configuration − Downloads a switch configuration file from a TFTP
server.
<ipaddr> − The IP address of the TFTP server.
<path_filename 64> − The DOS path and filename of the switch
configuration file, up to 64 characters, on the TFTP server. For
example, C:\31xx.had.
startup − Indicates the Configuration file is to be downloaded to the
startup config.
firmware − Downloads and installs firmware on the Switch from a
TFTP server.
<string 64> − The DOS path and filename of the firmware file, up to
64 characters, on the TFTP server. For example, C:\31xx.had.
Only Administrator or operator-level users can issue this command.
79
14 14 14 14