Download/Upload Commands - D-Link DES-3010F Command Line Interface Reference Manual

The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
download
upload
enable autoconfig
disable autoconfig
show autoconfig
Each command is listed, in detail, in the following sections.
download
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To download a firmware file:
DES-3026:4#download firmware 10.48.74.121 c:\DES-3026 b08.had
Command: download firmware 10.48.74.121 c:\DES-3026 b08.had
Connecting to server................... Done.
Download firmware.................... Done. Do not power off!
Please wait, programming flash........ Done.
Saving current settings to NV-RAM......Done.
Please wait, the switch is rebooting....
DES-30XX Layer 2 Switch CLI Reference Manual
D
Parameters
[firmware <ipaddr> <path_filename 64> | configuration <ipaddr>
<path_filename 64> {increment}]
[configuration | log] <ipaddr> <path_filename 64>
Used to download and install new firmware or a switch configuration
file from a TFTP server.
download [firmware <ipaddr> <path_filename 64> |
configuration <ipaddr> <path_filename 64> {increment}]
This command is used to download a new firmware or a switch
configuration file from a TFTP server.
firmware − Download and install new firmware on the Switch from a
TFTP server.
configuration − Download a switch configuration file from a TFTP
server.
<ipaddr> − The IP address of the TFTP server.
<path_filename> − The DOS path and filename of the firmware or
switch configuration file on the TFTP server. For example,
C:\3024.had.
increment − Allows the download of a partial switch configuration file.
This allows a file to be downloaded that will change only the Switch
parameters explicitly stated in the configuration file. All other switch
parameters will remain unchanged.
Only administrator-level users can issue this command.
/U
OWNLOAD
52
C
PLOAD OMMANDS
8