Rs232 Port - GE G30 Instruction Manual
Generator protection system 7.6x
Hide thumbs
Also See for G30:
- Instruction manual (698 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (614 pages)
Table of Contents
Advertisement
CHAPTER 3: INSTALLATION
WIRING
Figure 3-31: RTD connections
3
3.3.8 RS232 port
On the enhanced and standard front panels is a nine-pin RS232C serial port for programming with a computer. All that is
required to use this interface is a computer running the EnerVista UR Setup software provided with the relay. Cabling for
the RS232 port is shown in the following figure for the nine-pin connector on the UR and nine or 25-pin connector on a
computer.
The baud rate for this port can be set, with a default of 115200 bps.
Figure 3-32: RS232 front panel port connection
G30 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
3-33
Advertisement
Table of Contents
