Activate Relay - GE G30 Instruction Manual

Generator protection system 7.6x
Hide thumbs Also See for G30:
Table of Contents

Advertisement

CHAPTER 3: INSTALLATION
The clock configuration LED status is as follows:
Flashing green — loop timing mode while receiving a valid data packet
Flashing yellow — internal mode while receiving a valid data packet
Solid red — (switch to) internal timing mode while not receiving a valid data packet
The link/activity LED status is as follows:
Flashing green — FPGA is receiving a valid data packet
Solid yellow — FPGA is receiving a "yellow bit" and remains yellow for each "yellow bit"
Solid red — FPGA is not receiving a valid packet or the packet received is invalid

3.5 Activate relay

The relay is in the default "Not Programmed" state when it leaves the factory. When powered up successfully, looking at
the front panel, the "Trouble" LED is on and the "In Service" LED is off. The relay in the "Not Programmed" state blocks
signaling of any output relay. These conditions remain until the relay is explicitly put into "Programmed" state.
RELAY SETTINGS:
Not Programmed
The relay can be activated on the front panel or in the EnerVista software.
To activate the relay using the front panel:
1.
Press the
key until the
MENU
2.
Press the
right arrow until the
MESSAGE
3.
Press the
down arrow until the
MESSAGE
4.
Press the
right arrow until the
MESSAGE
G30 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 3-62: Status LEDs
When the relay is powered up, the "Trouble LED" is on, the "In Service" LED is off, and this message
displays, indicating that the relay is in the "Not Programmed" state and is safeguarding (output
relays blocked) against the installation of a relay whose settings have not been entered. This
message remains until the relay is explicitly put into "Programmed" state.
header flashes momentarily and the
SETTINGS
message displays.
SECURITY
message displays.
INSTALLATION
Not Programmed message displays.
RELAY SETTINGS:
ACTIVATE RELAY
message displays.
PRODUCT SETUP
3
3-53

Advertisement

Table of Contents
loading

Table of Contents