GE G30 Instruction Manual page 136
Generator protection system 7.6x
Hide thumbs
Also See for G30:
- Instruction manual (698 pages) ,
- Communications manual (532 pages) ,
- Communications manual (526 pages)
Table of Contents
Advertisement
ENERVISTA SOFTWARE INTERFACE
View In Template Mode option.
2.
Enter the template password if prompted, then click OK to apply the template.
Once the template has been applied, users are limited to view and edit the settings specified by the template. The effect of
applying the template to the phase time overcurrent settings is shown.
4
Viewing the settings in template mode also modifies the settings menu, showing only the settings categories that contain
editable settings. The effect of applying the template to a typical settings menu is shown as follows.
Figure 4-7: Applying templates using the View in Template Mode settings command
Use the following procedure to display settings available for editing and settings locked by the template.
1.
Right-click the device in the Online or Offline Window area and apply the template by selecting the Template Mode >
View All Settings option.
2.
Enter the template password then click OK to apply the template.
Once the template has been applied, users are limited to edit the settings specified by the template, but all settings are
shown. The effect of applying the template to the phase time overcurrent settings is shown as follows.
4-8
Figure 4-6: Applying templates using the View in Template Mode command
G30 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES
Advertisement
Table of Contents
