GE G30 Instruction Manual page 385

CHAPTER 5: SETTINGS
Configuring a composite curve with an increase in operating time at increased pickup multiples is not allowed. If
this is attempted, the EnerVista software generates an error message and discards the proposed changes.
5.5.7.5 Standard recloser curves
The following graphs display standard recloser curves available for the G30.
G30 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 5-80: Composite recloser curve with HCT enabled
Figure 5-81: Recloser curves GE101 to GE106
SYSTEM SETUP
5
5-171