Rs232 Program Port; Keypad - GE Multilin 369 Quick Start Manual

FACEPLATE INTERFACE
3.1.3

RS232 Program Port

3.1.4

Keypad

3–16
FIGURE 3–1: LED Indicators - Enhanced Faceplate
FIGURE 3–2: LED Indicators - Basic Faceplate
This port is intended for connection to a portable PC. Setpoint files may be created at any
location and downloaded through this port using the EnerVista 369 Setup software. Local
interrogation of Setpoints and Actual Values is also possible. New firmware may be
downloaded to the 369 flash memory through this port. Upgrading of the relay firmware
does not require a hardware EPROM change.
The 369 messages are organized into pages under the main headings, Setpoints and
Actual Values. The [SETPOINTS] key is used to navigate through the page headers of the
programmable parameters. The [ACTUAL VALUES] key is used to navigate through the
page headers of the measured parameters.
Each page is broken down further into logical subgroups of messages. The [PAGE] up and
down keys may be used to navigate through the subgroups.
• [SETPOINTS]: This key may be used to navigate through the page headers of the
programmable parameters. Alternately, one can press this key followed by using
the Page Up / Page Down keys.
• [ACTUAL VALUES]: This key is used to navigate through the page headers of the
measured parameters. Alternately, one can scroll through the pages by pressing
the Actual Values key followed by using the Page Up / Page Down keys.
CHAPTER 3: USER INTERFACES
369 MOTOR MANAGEMENT RELAY – QUICKSTART GUIDE