GE G30 Instruction Manual page 332

PRODUCT SETUP
Appendix A: FlexAnalog Parameters. The parameter index number shown in any of the tables is used to expedite the
selection of the parameter on the relay display. It can be time-consuming to scan through the list of parameters via the
relay keypad/display—entering this number via the relay keypad causes the corresponding parameter to display.
DATA LOGGER CONFIG
selected to "Off" without overwriting old data.
5.3.11 User-programmable LEDs
5.3.11.1 Menu - Enhanced and standard front panels
SETTINGS  PRODUCT SETUP  USER-PROGRAMMABLE LEDS
 USER-PROGRAMMABLE
 LEDS
5.3.11.2 Menu - Graphical front panel
5
SETTINGS  PRODUCT SETUP  USER-PROGRAMMABLE LEDS
 USER-PROGRAMMABLE
 LEDS
The LEDs can be customized to illuminate when a selected FlexLogic operand is in the logic 1 state. The trip and alarm
LEDs can also be customized in a similar manner. To ensure correct functionality of all LEDs, an LED test feature is also
provided.
5.3.11.3 LED test
SETTINGS  PRODUCT SETUP  USER-PROGRAMMABLE LEDS  LED TEST
 LED TEST

When enabled, the LED test can be initiated from any digital input or user-programmable condition, such as a user-
programmable pushbutton. The control operand is configured under the
LEDs, including the LEDs of the optional user-programmable pushbuttons.
For the enhanced and standard front panels, the test consists of the following three stages:
1. All 62 LEDs on the relay are illuminated. This is a quick test to verify if any of the LEDs is "burned." This stage lasts as
long as the control input is on, up to a maximum of one minute. After one minute, the test ends.
5-118
— This display presents the total amount of time that the Data Logger can record the channels not
 LED TEST


 TRIP & ALARM LEDS


 USER-PROGRAMMABLE

 LED 1
 USER-PROGRAMMABLE

 LED 48
 LED TEST


 TRIP & ALARM LEDS


 EVENT CAUSE LED 1


 EVENT CAUSE LED 9


LED TEST FUNCTION:

Disabled
LED TEST CONTROL:

Off
See below
See page 5-121
See page 5-121

See below
See page 5-121
See page 5-122

Range: Disabled, Enabled
Range: FlexLogic operand
LED TEST CONTROL
G30 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
setting. The test covers all