Ipv6 Bgp Route Reflector Configuration Example - HPE 5800 Series Configuration Manual

Peer
10::2
9:3::2
9:1::2
# Display IPv6 peer information on Switch C.
[SwitchC] display bgp ipv6 peer
BGP local router ID : 3.3.3.3
Local AS number : 65009
Total number of peers : 2
Peer
9:3::1
9:2::2
Switch A and Switch B have established an EBGP connection. Switch B, C, and D have
established IBGP connections to each other.

IPv6 BGP route reflector configuration example

Network requirements
In Figure 100, Switch B receives an EBGP update and sends it to Switch C, which is configured as a
route reflector with two clients: Switch B and Switch D.
Switch B and Switch D need not establish an IBGP connection because Switch C reflects updates
between them.
Figure 100 Network diagram
Vlan-int100
1::1/64
Switch A
Vlan-int200
100::2/96
AS 100
Configuration procedure
Configure IPv6 addresses for VLAN interfaces. (Details not shown.)
1.
Configure IPv6 BGP basic functions:
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] bgp 100
[SwitchA-bgp] router-id 1.1.1.1
[SwitchA-bgp] ipv6-family
[SwitchA-bgp-af-ipv6] peer 100::2 as-number 200
AS MsgRcvd
65008
65009
65009
AS MsgRcvd
65009
65009
Reflector
Vlan-int300
101::1/96
Switch C
IBGP
Vlan-int200
100::1/96
Vlan-int300
101::2/96
Switch B
MsgSent OutQ PrefRcv Up/Down
3 3 0
2 3 0
2 4 0
Peers in established state : 2
MsgSent OutQ PrefRcv Up/Down
4 4 0
4 5 0
Route
Vlan-int100
102::1/96
IBGP
Vlan-int100
102::2/96
AS 200
Switch D
339
State
0 00:01:16 Established
0 00:00:40 Established
0 00:00:19 Established
State
0 00:02:18 Established
0 00:01:52 Established