HPE 5800 Series Configuration Manual page 113
Layer 3 - ip routing
Hide thumbs
Also See for 5800 Series:
- Installation manual (126 pages) ,
- Configuration manual (412 pages) ,
- Configuration manuals (259 pages)
Table of Contents
Advertisement
Figure 31 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure OSPF basic functions:
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] router id 1.1.1.1
[SwitchA] ospf 100
[SwitchA-ospf-100] area 0
[SwitchA-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255
[SwitchA-ospf-100-area-0.0.0.0] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] router id 2.2.2.2
[SwitchB] ospf 100
[SwitchB-ospf-100] area 0
[SwitchB-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255
[SwitchB-ospf-100-area-0.0.0.0] quit
# Configure Switch C.
<SwitchC> system-view
[SwitchC] router id 3.3.3.3
[SwitchC] ospf 100
[SwitchC-ospf-100] area 0
[SwitchC-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255
[SwitchC-ospf-100-area-0.0.0.0] quit
Configure OSPF GR:
3.
# Configure Switch A as the non-IETF standard OSPF GR Restarter: enable the link-local
signaling capability, the out-of-band re-synchronization capability, and non-IETF standard
Graceful Restart capability for OSPF process 100.
[SwitchA-ospf-100] enable link-local-signaling
[SwitchA-ospf-100] enable out-of-band-resynchronization
[SwitchA-ospf-100] graceful-restart
[SwitchA-ospf-100] return
# Configure Switch B as the GR Helper: enable the link-local signaling capability and the
out-of-band re-synchronization capability for OSPF process 100.
[SwitchB-ospf-100] enable link-local-signaling
102
Advertisement
Table of Contents
Troubleshooting
