Configuring A Continue Clause - HPE 5800 Series Configuration Manual

Step
Set the next hop.
9.
10. Inject routing information to a
specified ISIS level.
11. Set the local preference for
BGP routing information.
12. Set MPLS label.
13. Set the ORIGIN attribute for
BGP routes.
14. Set the preference for the
routing protocol.
15. Set a preferred value for BGP
routes.
16. Set a tag value for RIP, OSPF
or IS-IS route.
17. Configure FRR.

Configuring a continue clause

When you configure a continue clause for a routing policy, follow these guidelines:
•
If you configure the same apply clause that set different values (including the apply
community and apply extcommunity clauses with the additive keyword) on nodes that are
combined by the continue clause, the apply clause configured on the last matching node takes
effect.
•
If you configure the apply community clause for multiple nodes that are combined by the
continue clause, the apply comm-list delete clause configured on the current node cannot
delete the COMMUNITY attributes set by preceding nodes.
To configure a continue clause for a routing policy:
Step
Enter system view.
1.
Create a routing policy and
2.
enter routing policy view.
Command
•
Set the next hop for IPv4
routes:
apply ip-address next-hop
ip-address
•
Set the next hop for IPv6
routes:
apply ipv6 next-hop
ipv6-address
apply isis { level-1 | level-1-2 |
level-2 }
apply local-preference preference
apply mpls-label
apply origin { egp as-number | igp
| incomplete }
apply preference preference
apply preferred-value
preferred-value
apply tag value
apply fast-reroute
{ backup-interface interface-type
interface-number
[ backup-nexthop ip-address ] }
Command
system-view
route-policy route-policy-name
{ deny | permit } node
node-number
356
Remarks
Optional.
Not set by default.
The apply ip-address
next-hop and apply ipv6
next-hop commands do not
apply to redistributed IPv4 and
IPv6 routes, respectively.
Optional.
Not configured by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not configured by default.
Remarks
N/A
Not created by default.