Injecting A Local Ipv6 Route; Configuring A Preferred Value For Routes From A Peer Or Peer Group - HPE 5800 Series Configuration Manual

Step
Specify a router ID.
3.
Enter IPv6 address family
4.
view or IPv6 BGP-VPN
instance view.
Specify an IPv6 peer.
5.

Injecting a local IPv6 route

Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view or IPv6 BGP-VPN
instance view.
Inject a local route into the
4.
IPv6 BGP routing table.
Configuring a preferred value for routes from a peer or peer
group
If you both reference a routing policy and use the command peer { ipv6-group-name | ipv6-address }
preferred-value value to set a preferred value for routes from a peer, the routing policy sets the
specific preferred value for routes matching it. If the preferred value in the routing policy is zero, the
routes use the value set with the peer { ipv6-group-name | ipv6-address } preferred-value value
command. For how to use a routing policy to set a preferred value, see the command peer
{ group-name | ipv4-address | ipv6-address } route-policy route-policy-name { import | export } in
this document, and the command apply preferred-value preferred-value in Layer 3
Command Reference.
To configure a preferred value for routes received from a peer or peer group:
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view or IPv6 BGP-VPN
instance view.
Configure a preferred value
4.
for routes received from an
IPv6 peer or peer group.
Command
router-id router-id
ipv6-family [ vpn-instance
vpn-instance-name ]
peer ipv6-address as-number
as-number
Command
system-view
bgp as-number
ipv6-family [ vpn-instance
vpn-instance-name ]
network ipv6-address
prefix-length [ route-policy
route-policy-name | short-cut ]
Command
system-view
bgp as-number
ipv6-family [ vpn-instance
vpn-instance-name ]
peer { ipv6-group-name |
ipv6-address } preferred-value
value
318
Remarks
Optional.
Required, if no IP addresses are
configured for any interfaces.
N/A
N/A
Remarks
N/A
N/A
N/A
Not added by default.
—
IP Routing
Remarks
N/A
N/A
N/A
By default, the preferred value is
0.
IPv6 BGP-VPN instance view
does not support the
ipv6-group-name argument.