Ospfv3 Gr Configuration Example - HPE 5800 Series Configuration Manual

Destination: 3::2/128
NextHop
Interface
Destination: 4::/64
NextHop
Interface
Destination: 4::1/128
NextHop
Interface
Destination: FE80::/10
NextHop
Interface

OSPFv3 GR configuration example

Network requirements
•
As shown in
same OSPFv3 routing domain are GR capable.
•
Switch A acts as the GR Restarter. Switch B and Switch C are the GR Helpers, and synchronize
their LSDBs with Switch A through out-of-band (OOB) communication of GR.
Figure 92 Network diagram
Configuration procedure
Configure IPv6 addresses for interfaces. (Details not shown.)
1.
Configure OSPFv3 basic functions:
2.
# On Switch A, enable OSPFv3 process 1, enable GR, and set the router ID to 1.1.1.1.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3 1
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] graceful-restart enable
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ospfv3 1 area 1
: ::1
: InLoop0
: 4::1
: Vlan400
: ::1
: InLoop0
: ::
: NULL0
Figure 92, Switch A, Switch B, and Switch C that belong to the same AS and the
293
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0