Configuring An Ipv6 Bgp Route Reflector - HPE 5800 Series Configuration Manual

Step
Advertise the COMMUNITY
4.
attribute to an IPv6 peer or
peer group.
Advertise the extended
5.
community attribute to an
IPv6 peer or peer group.
To advertise the COMMUNITY attribute to an IPv6 peer (IPv6 BGP-VPN instance view):
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 BGP-VPN
3.
instance view.
Advertise the COMMUNITY
4.
attribute to an IPv6 peer.
Applying a routing policy to routes advertised to a peer or peer group
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view.
Apply a routing policy to
4.
routes advertised to an IPv6
peer or peer group.

Configuring an IPv6 BGP route reflector

In general, because the route reflector forwards routing information between clients, you are not
required to make clients of a route reflector fully meshed. If clients are fully meshed, Hewlett Packard
Enterprise recommends disabling route reflection between clients to reduce routing costs.
If a cluster has multiple route reflectors, you must specify the same cluster ID for these route
reflectors to avoid routing loops.
To configure an IPv6 BGP route reflector:
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view.
Configure the router as a
4.
route reflector and specify an
IPv6 peer or peer group as a
client.
Command
peer { ipv6-group-name |
ipv6-address }
advertise-community
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Command
system-view
bgp as-number
ipv6-family vpn-instance
vpn-instance-name
peer ipv6-address
advertise-community
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } reflect-client
334
Remarks
By default, no COMMUNITY
attribute is advertised to any IPv6
peer or peer group.
By default, no extended
community attribute is advertised
to any IPv6 peer or peer group.
Remarks
N/A
By default, BGP is not enabled.
N/A
By default, no COMMUNITY
attribute is advertised to any IPv6
peer.
Remarks
N/A
N/A
N/A
Not applied by default.
Remarks
N/A
N/A
N/A
Not configured by default.