Ospfv3 Dr Election Configuration Example - HPE 5800 Series Configuration Manual

*Destination: 2001:1::/64
Type
NextHop
*Destination: 2001:2::/64
Type
NextHop
*Destination: 2001:3::/64
Type
NextHop
Configure Area 2 as a totally stub area:
4.
# Configure Area 2 as a totally stub area on Switch C.
[SwitchC-ospfv3-1-area-0.0.0.2] stub no-summary
# Display OSPFv3 routing table information on Switch D. Route entries are reduced. All
non-direct routes are removed, except the default route.
[SwitchD] display ospfv3 routing
E1 - Type 1 external route,
E2 - Type 2 external route,
------------------------------------------------------------------------
*Destination: ::/0
Type
NextHop
*Destination: 2001:2::/64
Type
NextHop

OSPFv3 DR election configuration example

Network requirements
•
In Figure
the DR.
•
The priority of Switch C is 2, the second highest priority on the network, so it becomes the BDR.
•
The priority of Switch B is 0, so it cannot become the DR.
•
Switch D has the default priority 1.
: IA
: FE80::F40D:0:93D0:1
: I
: directly-connected
: IA
: FE80::F40D:0:93D0:1
OSPFv3 Router with ID (4.4.4.4) (Process 1)
: IA
: FE80::F40D:0:93D0:1
: I
: directly-connected
90, the priority of Switch A is 100, the highest priority on the network, so it becomes
IA - Inter area route,
* - Selected route
287
Cost : 3
Interface: Vlan400
Cost : 1
Interface: Vlan400
Cost : 4
Interface: Vlan400
I - Intra area route
Cost : 11
Interface: Vlan400
Cost : 1
Interface: Vlan400