Bfd For Ipv6 Bgp Configuration Example - HPE 5800 Series Configuration Manual

ORF advertise capability based on prefix (type 64):
Local: both
Negotiated: send
Peer Preferred Value: 0
IPsec policy name: policy002, SPI :54321
Routing policy configured:
No routing policy is configured
The output shows that both IBGP and EBGP neighbor relationships have been established and
all protocol packets are protected by IPsec.

BFD for IPv6 BGP configuration example

Network requirements
•
As shown in
•
Establish two IBGP connections between Switch A and Switch C. When both links are working,
Switch C adopts the link Switch A<—>Switch B<—>Switch C to exchange packets with network
1200::0/64. Configure BFD over the link. Then if the link fails, BFD can quickly detect the failure
and notify it to IPv6 BGP. Then the link Switch A<—>Switch D<—>Switch C takes effect
immediately.
Figure 102 Network diagram
Device
Switch A
Switch B
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure OSPFv3 to make sure Switch A and Switch C are reachable to each other. (Details
2.
not shown.)
Configure IPv6 BGP on Switch A:
3.
# Establish two IBGP connections between Switch A and Switch C.
Figure 102, configure OSPFv3 as the IGP in AS 200.
Interface IP address
Vlan-int100 3000::1/64
Vlan-int200 2000::1/64
Vlan-int100 3000::2/64
Vlan-int101 3001::2/64
Device
Switch C
Switch D
345
Interface IP address
Vlan-int101 3001::3/64
Vlan-int201 2001::3/64
Vlan-int200 2000::2/64
Vlan-int201 2001::2/64