Ospfv3 Route Redistribution Configuration Example - HPE 5800 Series Configuration Manual

----------------------------------------------------------------------
Neighbor ID
1.1.1.1
2.2.2.2
3.3.3.3
Restart DR and BDR election:
4.
# Use the shutdown and undo shutdown commands on interfaces to restart DR and BDR
election. (Details not shown.)
# Display neighbor information on Switch A. Switch C becomes the BDR.
[SwitchA] display ospfv3 peer
----------------------------------------------------------------------
Neighbor ID
2.2.2.2
3.3.3.3
4.4.4.4
# Display neighbor information on Switch D. Switch A becomes the DR.
[SwitchD] display ospfv3 peer
----------------------------------------------------------------------
Neighbor ID
1.1.1.1
2.2.2.2
3.3.3.3

OSPFv3 route redistribution configuration example

Network requirements
•
In Figure
•
OSPFv3 process 1 and OSPFv3 process 2 are enabled on Switch B. Switch B communicates
with Switch A and Switch C through OSPFv3 process 1 and OSPFv3 process 2, respectively.
•
Configure OSPFv3 process 2 to redistribute direct routes and the routes from OSPFv3 process
1 on Switch B, and set the default metric for redistributed routes to 3. Switch C can then learn
the routes destined for 1::0/64 and 2::0/64, and Switch A cannot learn the routes destined for
3::0/64 or 4::0/64.
Figure 91 Network diagram
Configuration procedure
Configure IPv6 addresses for interfaces. (Details not shown.)
1.
Pri State
100 Full/DROther
0 Full/DROther
2 Full/Backup
OSPFv3 Area ID 0.0.0.0 (Process 1)
Pri State
0 Full/DROther
2 Full/Backup
1 Full/DROther
OSPFv3 Area ID 0.0.0.0 (Process 1)
Pri State
100 Full/DR
0 2-Way/DROther
2 Full/Backup
91, Switch A, Switch B, and Switch C are in Area 2.
Dead Time Interface
00:00:33 Vlan100
00:00:36 Vlan200
00:00:40 Vlan100
Dead Time Interface
00:00:31 Vlan200
00:00:39 Vlan100
00:00:37 Vlan200
Dead Time Interface
00:00:34 Vlan100
00:00:34 Vlan200
00:00:32 Vlan100
290
Instance ID
0
0
0
Instance ID
0
0
0
Instance ID
0
0
0