Configuration Prerequisites; Configuration Procedure; Configuring Ripng Route Control; Configuring An Additional Routing Metric - HPE 5800 Series Configuration Manual

Configuration prerequisites

Before you configure RIPng basic functions, complete the following tasks:
•
Enable IPv6 packet forwarding.
•
Configure an IP address for each interface, and make sure all nodes are reachable to one
another.

Configuration procedure

To configure the basic RIPng functions:
Step
Enter system view.
1.
Create a RIPng process and
2.
enter RIPng view.
Return to system view.
3.
Enter interface view.
4.
Enable RIPng on the
5.
interface.
NOTE:
If RIPng is not enabled on an interface, the interface will not send or receive any RIPng route.

Configuring RIPng route control

Before you configure RIPng, complete the following tasks:
•
Configure an IPv6 address on each interface, and make sure all nodes are reachable to one
another.
•
Configure RIPng basic functions.
•
Define an IPv6 ACL before using it for route filtering. For related information, see ACL and QoS
Configuration Guide.
•
Define an IPv6 address prefix list before using it for route filtering. For related information, see
"Configuring routing

Configuring an additional routing metric

An additional routing metric can be added to the metric of an inbound or outbound RIP route.
The outbound additional metric is added to the metric of a sent route. The route's metric in the
routing table is not changed.
The inbound additional metric is added to the metric of a received route before the route is added into
the routing table, so the route's metric is changed.
To configure an inbound or outbound additional routing metric:
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
ripng process-id enable
policies".
254
Remarks
N/A
Not created by default.
N/A
N/A
Disabled by default.