HPE 5800 Series Configuration Manual page 352
Layer 3 - ip routing
Hide thumbs
Also See for 5800 Series:
- Installation manual (126 pages) ,
- Configuration manual (412 pages) ,
- Configuration manuals (259 pages)
Table of Contents
Advertisement
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure the IBGP connection:
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] bgp 65008
[SwitchA-bgp] router-id 1.1.1.1
[SwitchA-bgp] ipv6-family
[SwitchA-bgp-af-ipv6] group ibgp internal
[SwitchA-bgp-af-ipv6] peer 1::2 group ibgp
[SwitchA-bgp-af-ipv6] quit
[SwitchA-bgp] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] bgp 65008
[SwitchB-bgp] router-id 2.2.2.2
[SwitchB-bgp] ipv6-family
[SwitchB-bgp-af-ipv6] group ibgp internal
[SwitchB-bgp-af-ipv6] peer 1::1 group ibgp
[SwitchB-bgp-af-ipv6] quit
[SwitchB-bgp] quit
Configure the EBGP connection:
3.
# Configure Switch C.
<SwitchC> system-view
[SwitchC] ipv6
[SwitchC] bgp 65009
[SwitchC-bgp] router-id 3.3.3.3
[SwitchC-bgp] ipv6-family
[SwitchC-bgp-af-ipv6] group ebgp external
[SwitchC-bgp-af-ipv6] peer 3::1 as-number 65008
[SwitchC-bgp-af-ipv6] peer 3::1 group ebgp
[SwitchC-bgp-af-ipv6] quit
[SwitchC-bgp] quit
# Configure Switch B.
[SwitchB-bgp] ipv6-family
[SwitchB-bgp-af-ipv6] group ebgp external
[SwitchB-bgp-af-ipv6] peer 3::2 as-number 65009
[SwitchB-bgp-af-ipv6] peer 3::2 group ebgp
[SwitchB-bgp-af-ipv6] quit
[SwitchB-bgp] quit
Configure IPsec policies:
4.
# On Switch A, create an IPsec proposal named tran1, and set the encapsulation mode to
transport mode, the security protocol to ESP, the encryption algorithm to DES, and
authentication algorithm to SHA1. Create an IPsec policy named policy001, specify the
manual mode for it, reference IPsec proposal tran1, set the SPIs of the inbound and outbound
SAs to 12345, and the keys for the inbound and outbound SAs using ESP to abcdefg.
341
Advertisement
Table of Contents
Troubleshooting
