Configuring A Priority For Ripng; Configuring Ripng Route Redistribution; Tuning And Optimizing The Ripng Network - HPE 5800 Series Configuration Manual

Step
Configure a filter policy
4.
to filter outgoing routes.

Configuring a priority for RIPng

Routing protocols have their own protocol priorities used for optimal route selection. You can set a
priority for RIPng manually. The smaller the value, the higher the priority.
To configure a RIPng priority:
Step
Enter system view.
1.
Enter RIPng view.
2.
Configure a RIPng priority.
3.

Configuring RIPng route redistribution

Step
Enter system view.
1.
Enter RIPng view.
2.
Configure a default routing
3.
metric for redistributed
routes.
Redistribute routes from
4.
another routing protocol.

Tuning and optimizing the RIPng network

This section describes how to tune and optimize the performance of the RIPng network, as well as
applications under special network environments. Before tuning and optimizing the RIPng network,
complete the following tasks:
•
Configure a network layer address for each interface.
•
Configure the basic RIPng functions.
Command
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name } export
[ protocol [ process-id ] ]
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
preference [ route-policy
route-policy-name ] preference
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
default cost cost
import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | route-policy
route-policy-name ] *
256
Remarks
By default, RIPng does not filter
outgoing routing information.
Remarks
N/A
N/A
Optional.
By default, the RIPng priority is
100.
Remarks
N/A
N/A
Optional.
The default metric of redistributed
routes is 0.
No route redistribution is
configured by default.