HPE 5800 Series Configuration Manual page 272

[SwitchC-Vlan-interface500] ripng 1 enable
[SwitchC-Vlan-interface500] quit
[SwitchC] interface vlan-interface 600
[SwitchC-Vlan-interface600] ripng 1 enable
[SwitchC-Vlan-interface600] quit
# Display the routing table of Switch B.
[SwitchB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE23:82F5
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Peer FE80::20F:E2FF:FE00:100
Dest 3::/64,
via FE80::20F:E2FF:FE00:100, cost
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost
# Display the routing table of Switch A.
[SwitchA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::200:2FF:FE64:8904
Dest 1::/64,
via FE80::200:2FF:FE64:8904, cost
Dest 4::/64,
via FE80::200:2FF:FE64:8904, cost
Dest 5::/64,
via FE80::200:2FF:FE64:8904, cost
Dest 3::/64,
via FE80::200:2FF:FE64:8904, cost
Configure route filtering:
3.
# Configure Switch B to filter incoming and outgoing routes.
[SwitchB] acl ipv6 number 2000
[SwitchB-acl6-basic-2000] rule deny source 3::/64
[SwitchB-acl6-basic-2000] rule permit
[SwitchB-acl6-basic-2000] quit
[SwitchB] ripng 1
[SwitchB-ripng-1] filter-policy 2000 import
[SwitchB-ripng-1] filter-policy 2000 export
# Display routing tables on Switch B and Switch A.
[SwitchB] display ripng 1 route
on Vlan-interface100
1, tag 0, A, 6 Sec
1, tag 0, A, 6 Sec
on Vlan-interface200
1, tag 0, A, 11 Sec
1, tag 0, A, 11 Sec
1, tag 0, A, 11 Sec
on Vlan-interface100
1, tag 0, A, 31 Sec
2, tag 0, A, 31 Sec
2, tag 0, A, 31 Sec
1, tag 0, A, 31 Sec
261