HPE 5800 Series Configuration Manual page 325
Layer 3 - ip routing
Hide thumbs
Also See for 5800 Series:
- Installation manual (126 pages) ,
- Configuration manual (412 pages) ,
- Configuration manuals (259 pages)
Table of Contents
Advertisement
Figure 98 Network diagram
Configuration procedure
Configure IPv4 and IPv6 addresses and subnet masks for each interface on the switches.
1.
(Details not shown.)
Configure IS-IS on the switches to make sure Switch A, Switch B, Switch C, and Switch D can
2.
communicate with each other at Layer 3 and dynamic route update can be implemented among
them with IS-IS. (Details not shown.)
Configure IPv6 IS-IS MTR:
3.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis
[SwitchA-isis-1] cost-style wide
[SwitchA-isis-1] multiple-topology ipv6-unicast
# Configure Switch B.
<SwitchB> system-view
[SwitchB] isis
[SwitchB-isis-1] cost-style wide
[SwitchB-isis-1] multiple-topology ipv6-unicast
# Configure Switch D.
<SwitchD> system-view
[SwitchD] isis
[SwitchD-isis-1] cost-style wide
[SwitchD-isis-1] multiple-topology ipv6-unicast
Verify the configuration:
4.
# Display the IS-IS routing table of the IPv6 topology on Switch A.
[SwitchA-isis-1] display isis route ipv6
Destination: 12::
Flag
Next Hop
Route information for ISIS(1)
-----------------------------
ISIS(1) IPv6 Level-1 Forwarding Table
-------------------------------------
: D/L/-
: Direct
314
PrefixLen: 64
Cost
: 4
Interface: Vlan12
Advertisement
Table of Contents
Troubleshooting
