Routing Policy Configuration Examples; Routing Policy Configuration Example For Ipv4 Route Redistribution - HPE FlexNetwork 5510 HI Series Configuration Manual

Task
Display MAC list statistics.
Display routing policy information.
Clear IPv4 prefix list statistics.
Clear IPv6 prefix list statistics.
Clear MAC list statistics.

Routing policy configuration examples

Routing policy configuration example for IPv4 route
redistribution
Network requirements
As shown in
with Switch C by using IS-IS.
On Switch B, enable route redistribution from IS-IS to OSPF. Use a routing policy to set the cost of
route 172.17.1.0/24 to 100 and the tag of route 172.17.2.0/24 to 20.
Figure 117 Network diagram
Switch A
Configuration procedure
Specify IP addresses for interfaces. (Details not shown.)
1.
Configure IS-IS:
2.
# Configure Switch C.
<SwitchC> system-view
[SwitchC] isis
[SwitchC-isis-1] is-level level-2
[SwitchC-isis-1] network-entity 10.0000.0000.0001.00
[SwitchC-isis-1] quit
[SwitchC] interface vlan-interface 200
[SwitchC-Vlan-interface200] isis enable
[SwitchC-Vlan-interface200] quit
[SwitchC] interface vlan-interface 201
Figure 117, Switch B exchanges routing information with Switch A by using OSPF and
OSPF
Vlan-int100
192.168.1.2/24
Switch B
Vlan-int100
192.168.1.1/24
Command
display mac-list [ name mac-list-name ]
display route-policy [ name route-policy-name ]
reset ip prefix-list [ prefix-list-name ]
reset ipv6 prefix-list [ prefix-list-name ]
reset mac-list [ mac-list-name ]
IS-IS
Vlan-int200
192.168.2.2/24
Vlan-int200
192.168.2.1/24
Switch C
500
Vlan-int201
172.17.1.1/24
Vlan-int202
172.17.2.1/24
Vlan-int203
172.17.3.1/24