HPE 5800 Series Configuration Manual page 109

[SwitchB-Vlan-interface1] quit
# Configure Switch C.
[SwitchC] interface vlan-interface 1
[SwitchC-Vlan-interface1] ospf dr-priority 2
[SwitchC-Vlan-interface1] quit
# Display neighbor information on Switch D.
<SwitchD> display ospf peer verbose
OSPF Process 1 with Router ID 4.4.4.4
Area 0.0.0.0 interface 192.168.1.4(Vlan-interface1)'s neighbors
Router ID: 1.1.1.1
State: Full
DR: 192.168.1.4
Dead timer due in 31
Neighbor is up for 00:11:17
Authentication Sequence: [ 0 ]
Router ID: 2.2.2.2
State: Full
DR: 192.168.1.4
Dead timer due in 35
Neighbor is up for 00:11:19
Authentication Sequence: [ 0 ]
Router ID: 3.3.3.3
State: Full
DR: 192.168.1.4
Dead timer due in 33
Neighbor is up for 00:11:15
Authentication Sequence: [ 0 ]
The DR and BDR have no change, because the priority configuration does not take effect
immediately.
Restart OSPF process:
4.
# Restart the OSPF process of Switch D.
<SwitchD> reset ospf 1 process
Warning : Reset OSPF process? [Y/N]:y
# Display neighbor information on Switch D.
<SwitchD> display ospf peer verbose
OSPF Process 1 with Router ID 4.4.4.4
Area 0.0.0.0 interface 192.168.1.4(Vlan-interface1)'s neighbors
Router ID: 1.1.1.1
State: Full
DR: 192.168.1.1
Neighbors
Address: 192.168.1.1
Mode:Nbr is Slave
BDR: 192.168.1.3
sec
Address: 192.168.1.2
Mode:Nbr is Slave
BDR: 192.168.1.3
sec
Address: 192.168.1.3
Mode:Nbr is Slave
BDR: 192.168.1.3
sec
Neighbors
Address: 192.168.1.1
Mode: Nbr is Slave
BDR: 192.168.1.3
98
GR State: Normal
Priority: 100
MTU: 0
GR State: Normal
Priority: 0
MTU: 0
GR State: Normal
Priority: 2
MTU: 0
Priority: 100
MTU: 0
GR State: Normal