Configuring Ipv6 Is-Is Route Control - HPE 5800 Series Configuration Manual

Step
Enable IPv6 for an IS-IS
7.
process on the interface.

Configuring IPv6 IS-IS route control

Before you configure IPv6 IS-IS route control, complete basic IPv6 IS-IS configuration.
For information about ACL, see ACL and QoS Configuration Guide.
For information about routing policy and IPv6 prefix list, see
To configure IPv6 IS-IS route control:
Step
Enter system view.
1.
Enter IS-IS view.
2.
Specify the preference for
3.
IPv6 IS-IS routes.
Configure an IPv6 IS-IS
4.
summary route.
Generate an IPv6 IS-IS
5.
default route.
Configure IPv6 IS-IS to
6.
filter incoming routes.
Configure IPv6 IS-IS to
7.
redistribute routes from
another routing protocol.
Configure the maximum
8.
number of redistributed
Level 1/Level 2 IPv6
routes.
Configure the filtering of
9.
outgoing redistributed
routes.
10. Enable route leaking.
11. Specify the maximum
number of ECMP routes for
load balancing.
Command
isis ipv6 enable [ process-id ]
Command
system-view
isis [ process-id ]
ipv6 preference { route-policy
route-policy-name | preference } *
ipv6 summary ipv6-prefix prefix-length
[ avoid-feedback |
generate_null0_route | [ level-1 |
level-1-2 | level-2 ] | tag tag ] *
ipv6 default-route-advertise [ [ level-1 |
level-1-2 | level-2 ] | route-policy
route-policy-name ] *
ipv6 filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name |
route-policy route-policy-name } import
ipv6 import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | [ level-1 |
level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
ipv6 import-route limit number
ipv6 filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name |
route-policy route-policy-name } export
[ protocol [ process-id ] ]
ipv6 import-route isisv6 level-2 into
level-1 [ filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name |
route-policy route-policy-name } | tag
tag ] *
ipv6 maximum load-balancing number
303
Remarks
Disabled by default.
"Configuring routing policies."
Remarks
N/A
N/A
Optional.
15 by default.
Optional.
Not configured by default.
Optional.
No IPv6 default route is
defined by default.
Optional.
No filtering policy is defined
by default.
Optional.
Not configured by default.
Optional.
The default setting is 8192
for the HPE 5800 Switch
Series and is 6144 for the
HPE 5820X Switch Series.
Optional.
Not configured by default.
Optional.
Not enabled by default.
Optional.
By default, the maximum
number of ECMP routes for
load balancing is 8.