Configuring Ipv6 Bgp Community - HPE 5800 Series Configuration Manual

If a peer was added into an EBGP peer group, you cannot specify any AS number for the peer group.
To configure a pure EBGP group:
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view.
Create an EBGP peer group.
4.
Configure the AS number for
5.
the peer group.
Add an IPv6 peer into the
6.
peer group.
Creating a mixed EBGP peer group
When creating a mixed EBGP peer group, you must create a peer and specify its AS number, which
can be different from AS numbers of other peers; however, you cannot specify an AS number for the
EBGP peer group.
To create a mixed EBGP peer group:
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view.
Create an EBGP peer group.
4.
Specify the AS number of an
5.
IPv6 peer.
Add the IPv6 peer into the
6.
peer group.

Configuring IPv6 BGP community

When configuring IPv6 BGP community, you must configure a routing policy to define the
COMMUNITY attribute, and apply the routing policy to route advertisement.
For routing policy configuration, see
Advertising the COMMUNITY attribute to an IPv6 peer or peer group
To advertise the COMMUNITY attribute to an IPv6 peer or peer group (IPv6 address family view):
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view.
Command
system-view
bgp as-number
ipv6-family
group ipv6-group-name external
peer ipv6-group-name
as-number as-number
peer ipv6-address group
ipv6-group-name
Command
system-view
bgp as-number
ipv6-family
group ipv6-group-name external
peer ipv6-address as-number
as-number
peer ipv6-address group
ipv6-group-name
"Configuring routing
Command
system-view
bgp as-number
ipv6-family
333
Remarks
N/A
N/A
N/A
N/A
Not configured by default.
Not added by default.
Remarks
N/A
N/A
N/A
N/A
Not specified by default.
Not added by default.
policies."
Remarks
N/A
By default, BGP is not enabled.
N/A