HPE 5800 Series Configuration Manual page 369
Layer 3 - ip routing
Hide thumbs
Also See for 5800 Series:
- Installation manual (126 pages) ,
- Configuration manual (412 pages) ,
- Configuration manuals (259 pages)
Table of Contents
Advertisement
Figure 103 Network diagram
Configuration procedure
Specify IP addresses for interfaces. (Details not shown.)
1.
Configure IS-IS:
2.
# Configure Switch C.
<SwitchC> system-view
[SwitchC] isis
[SwitchC-isis-1] is-level level-2
[SwitchC-isis-1] network-entity 10.0000.0000.0001.00
[SwitchC-isis-1] quit
[SwitchC] interface vlan-interface 200
[SwitchC-Vlan-interface200] isis enable
[SwitchC-Vlan-interface200] quit
[SwitchC] interface vlan-interface 201
[SwitchC-Vlan-interface201] isis enable
[SwitchC-Vlan-interface201] quit
[SwitchC] interface vlan-interface 202
[SwitchC-Vlan-interface202] isis enable
[SwitchC-Vlan-interface202] quit
[SwitchC] interface vlan-interface 203
[SwitchC-Vlan-interface203] isis enable
[SwitchC-Vlan-interface203] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] isis
[SwitchB-isis-1] is-level level-2
[SwitchB-isis-1] network-entity 10.0000.0000.0002.00
[SwitchB-isis-1] quit
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] isis enable
[SwitchB-Vlan-interface200] quit
Configure OSPF and route redistribution:
3.
# Configure OSPF on Switch A.
<SwitchA> system-view
358
Advertisement
Table of Contents
Troubleshooting
