HPE 5800 Series Configuration Manual page 358

Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[SwitchA-Vlan-interface100] bfd min-transmit-interval 500
Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[SwitchA-Vlan-interface100] bfd min-receive-interval 500
Configure the detect multiplier as 7.
[SwitchA-Vlan-interface100] bfd detect-multiplier 7
[SwitchA-Vlan-interface100] quit
# Configure Switch C.
[SwitchC] bfd session init-mode active
[SwitchC] interface vlan-interface 101
Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[SwitchC-Vlan-interface101] bfd min-transmit-interval 500
Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[SwitchC-Vlan-interface101] bfd min-receive-interval 500
Configure the detect multiplier as 7.
[SwitchC-Vlan-interface101] bfd detect-multiplier 7
[SwitchC-Vlan-interface101] return
Verify the configuration:
6.
# Display the BFD session information on Switch C.
<SwitchC> display bfd session verbose
Total session number: 1
IPv6 Session working under Ctrl mode:
Local Discr: 17
Source IP: 3001::3
Destination IP: 3000::1
Session State: Up
Min Trans Inter: 500ms
Min Recv Inter: 500ms
Recv Pkt Num: 57
Hold Time: 2200ms
Running Up for: 00:00:06
Protocol: BGP6
Diag Info: No Diagnostic
The output shows that a BFD session is established between Switch A's VLAN-interface 100
and Switch C's VLAN-interface 101 and that BFD runs properly.
# Display IPv6 peer information on Switch C.
<SwitchC> display bgp ipv6 peer
BGP local router ID : 1.1.1.1
Local AS number : 200
Total number of peers : 2
Peer
2000::1
3000::1
The output shows that the neighborship between Switch A and Switch C is established.
Up session number: 1
Remote Discr: 13
Interface: Vlan-interface101
Act Trans Inter: 500ms
Act Detect Inter: 3000ms
Send Pkt Num: 53
Connect Type: Direct
Auth mode: None
Peers in established state : 2
AS MsgRcvd MsgSent OutQ PrefRcv Up/Down
200 7
200 7
347
Init mode: Active
10 0 0 00:01:05 Established
10 0 0 00:01:34 Established
State