Controlling Route Distribution And Reception; Configuration Prerequisites; Injecting A Local Ipv6 Mbgp Route; Configuring Ipv6 Mbgp Route Redistribution - HPE FlexFabric 5800 Series Configuration Manual

To configure a preferred value for routes from a peer or a peer group:
Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 MBGP address
3.
family view.
Specify a preferred value for
4.
routes received from the
IPv6 MBGP peer or the peer
group.

Controlling route distribution and reception

Refer to the following information for details about controlling route distribution and reception.

Configuration prerequisites

Before you configure this task, complete the following tasks:
•
Enable IPv6.
•
Configure basic IPv6 MBGP.

Injecting a local IPv6 MBGP route

Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 MBGP address
3.
family view.
Inject a network into the IPv6
4.
MBGP routing table.

Configuring IPv6 MBGP route redistribution

Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 MBGP multicast
3.
address family view.
Enable default route
4.
redistribution into the IPv6
MBGP routing table.
Enable route redistribution
5.
Command
system-view
bgp as-number
ipv6-family multicast
peer { ipv6-group-name |
ipv6-address } preferred-value
value
Command
system-view
bgp as-number
ipv6-family multicast
network ipv6-address
prefix-length [ route-policy
route-policy-name | short-cut ]
Command
system-view
bgp as-number
ipv6-family multicast
default-route imported
import-route protocol
480
Remarks
N/A
N/A
N/A
Optional.
The preferred value defaults to 0.
Remarks
N/A
N/A
N/A
Not injected by default.
Description
N/A
N/A
N/A
Optional.
Default route redistribution is not
allowed by default.
Not enabled by default.