Installing And Connecting The Its-Map0008 Wireless Modem - Bosch ICP-MAP5000-2 Installation Manual

Map 5000 series main panel intrusion alarm system
Hide thumbs Also See for ICP-MAP5000-2:
Table of Contents

Advertisement

MAP 5000
Installing the ICP-COM-IF relay module
2.14

Installing and connecting the ITS-MAP0008 wireless modem

The ITS-MAP0008 wireless modem is used for wireless transmission of data via GSM/GPRS.
The ITS-MAP0008 wireless modem can only be used when the ICP-MAP5000-COM MAP Main
Panel with IP Communicator is installed.
How to install and connect the ITS-MAP0008 wireless modem
The ITS-MAP0008 wireless modem is mounted on the enclosure back wall by means of two
screws (supplied with the enclosure). This means that there is no mounting location for an
LSA+ strip.
1.
2.
3.
4.
5.
Warning!
In order to avoid data loss on the SIM card, the wireless modem must be de-energized before
!
inserting or removing the SIM card.
Bosch Sicherheitssysteme GmbH
Insert the SIM card. Slide the card in from the top fully (card holder on the rear side of
the wireless modem) until it clicks into place. Pay attention to the insertion direction.
Using the cable ICP-MAP0152, connect the 9-pin SUB-D plug to the COM 1 connection of
the ICP-MAP0007 DE module (not supplied).
Connect the antenna to the FME female connector of the wireless modem.
Connect the black-red cable at output A or B of the power supply (terminal B = black,
terminal R = red), in addition to existing wires where appropriate.
Mount the small snap ferrite sleeve (contained in the accessory pack of the main panel)
on the black-red cable of the wireless modem close to the wireless modem.
Installation manual
Installation | en
37
2016.06 | 17 | F.01U.168.332

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Icp-map5000-com

Table of Contents