Installing And Connecting The Its-Map0008 Wireless Modem - Bosch MAP 5000 Instruction Manual

38 en | Installation
Installing the ICP-COM-IF relay module
2.14

Installing and connecting the ITS-MAP0008 wireless modem

The ITS-MAP0008 wireless modem is used for wireless transmission of data via GSM/GPRS.
The ITS-MAP0008 wireless modem can only be used when one of the following main panels is
installed:
–
–
The ITS-MAP0008 wireless modem is designed to provide the interface to GSM network to the
MAP Main Panel in order to realize an integrated dual-path SPT type Z with MAP5000
according to EN 50131-10 and EN 50136-2.
The ITS-MAP0008 wireless modem is not capable of working as a standalone SPT without the
connection to the MAP Main Panel.
How to install and connect the ITS-MAP0008 wireless modem
The ITS-MAP0008 wireless modem is mounted on the enclosure back wall by means of two
screws (supplied with the enclosure). This means that there is no mounting location for an
LSA+ strip.
1.
2.
3.
4.
5.
2018.08 | 23 | F.01U.168.332
MAP Main Panel with IP Communicator (ICP-MAP5000-COM)
MAP Main Panel Small with IP Communicator (ICP-MAP5000-SC)
Insert the SIM card. Slide the card in from the top fully (card holder on the rear side of
the wireless modem) until it clicks into place. Pay attention to the insertion direction.
Using the cable ICP-MAP0152, connect the 9-pin SUB-D plug to the COM 1 connection of
the ICP-MAP0007 DE module (not supplied).
Connect the antenna to the FME female connector of the wireless modem.
Connect the black-red cable at output A or B of the power supply (terminal B = black,
terminal R = red), in addition to existing wires where appropriate.
Mount the small snap ferrite sleeve (contained in the accessory pack of the main panel)
on the black-red cable of the wireless modem close to the wireless modem.
Installation manual
MAP 5000
Bosch Sicherheitssysteme GmbH