Planning The System With Icp-Map0012 Can Splitter Module - Bosch ICP-MAP5000-2 Installation Manual

10 en | Introduction
Wire diameter
Tab. 1.1: Cable lengths
The following applies for VdS
For remote operation of the IPP-MAP0005 power supply, a control center assigned to the
same area must be provided for indication of power supply trouble (trouble in mains supply /
battery).
1.5.2

Planning the system with ICP-MAP0012 CAN splitter module

4
Wiring with a CAN splitter module and a MAP LSN gateway module
2016.06 | 17 | F.01U.168.332
Wire cross-
section
0.8 mm 0.503 mm
0.8 mm 0.503 mm
0.8 mm 0.503 mm
0.8 mm 0.503 mm
1.0 mm 0.785 mm
1.0 mm 0.785 mm
1.0 mm 0.785 mm
1.0 mm 0.785 mm
1.0 mm 0.785 mm
1.0 mm 0.785 mm
1.0 mm 0.785 mm
When using a CAN splitter module to split the external BDB into two independent areas,
chose one of the following wiring possibilities:
ICP-MAP0012
Length A Length B
2
. 325 m
2
. 100 m
2
. 50 m
2
. 50 m
2
. 500 m
2
. 175 m
2
. 100 m
2
. 100 m
2
. 50 m
2
. 50 m
2
. 50 m
Installation manual
Length C
- - - - - -
135 m - - -
225 m - - -
50 m 50 m
- - - - - -
175 m - - -
325 m - - -
75 m 75 m
400 m - - -
125 m 125 m
50 m 50 m
ICP-MAP0010
Bosch Sicherheitssysteme GmbH
MAP 5000
Length D
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
50 m