Output Functions; Programmable Output Signals - Bosch ICP-MAP5000-2 Installation Manual

MAP 5000
Intrusion 24 Hour
Technical
Trouble
4.6

Output functions

4.6.1

Programmable output signals

The following functions can be programmed at outputs.
p = programmable
Behavior item type
Hold-up alarm
Duress alarm
External intrusion alarm
Internal intrusion alarm
Technical alarm
External system trouble
Internal system trouble
External intrusion trouble
Internal intrusion trouble
Technical trouble
Summary area armed
Area armed
Area disarmed
Area ready to arm
Internal program ON
Chime
Monitor (output follows Input)
Report failure panel alarm
(V1.2x)
Report failure intrusion and
tamper alarm (V1.2x)
Report failure summary alarm
Bosch Sicherheitssysteme GmbH
Yes Yes
Yes Yes
Yes Yes
Output is activated for ...
Hold-up (silent)
Hold-up (non silent)
Duress alarm
Intrusion alarm from unoccupied protection area
Intrusion alarm from disarmed area with
– activated internal program
– intrusion alarm 24h
Technical alarm
Power supply failure (p), battery trouble
Power supply failure, ground fault, printer trouble
Detector self test trouble
Anti-mask trouble
Technical trouble
One or more areas armed externally
Area x armed externally
Area x disarmed externally
Area x disarmed and ready to arm
Internal program x switched on
Detector has tripped chime, only if chime mode is
activated
Shows the actual status of the input: normal / active
Panel has received negative acknowledgment from
communicator as a result of report failure panel alarm
(only for panel firmware 1.2.x)
Panel has received negative acknowledgment from
communicator as a result of report failure intrusion and
tamper alarm (only for panel firmware 1.2.x)
Panel has received negative acknowledgment from
communicator due to report failure summary alarm
Installation manual
Initial set-up and programming | en
Yes Yes
Yes No
Yes Yes
2016.06 | 17 | F.01U.168.332
61