Mounting The Main Panel - Bosch ICP-MAP5000-2 Installation Manual

MAP 5000
Connecting the grounding cable to the hinged mounting plate
2.12

Mounting the main panel

This chapter describes the mounting of the following main panels:
–
–
How to mount the main panel
The main panel is mounted on the hinged mounting plate.
For information on how to mount modules on the hinged mounting plate, refer to Installing the
hinged mounting plate, page 32.
Ethernet cable
The Ethernet cable is used to provide a connection via Open Intrusion Interface (OII) to a
management system.
The Ethernet cable can alternatively be used for IP communication if the ICP-MAP5000-COM
MAP Main Panel with IP Communicator is installed.
For IP communication via an integrated IP communicator the following protocols are available:
–
–
–
How to mount the Ethernet cable
1.
2.
Bosch Sicherheitssysteme GmbH
MAP Main Panel (ICP-MAP5000-2)
MAP Main Panel with IP Communicator (ICP-MAP5000-COM) including the MAP GSM
module (ITS-MAP0008).
VdS 2465-S2
SIA DC-09 (TCP/IP and UDP/IP)
Conettix IP
Feed the Ethernet cable through the large snap ferrite sleeve (supplied in the accessory
pack of the main panel) with an additional turn.
Position the ferrite core as close as possible to the enclosure knockout inside the
enclosure.
Installation manual
Installation | en 35
2016.06 | 17 | F.01U.168.332