Connecting The Lsn Gateway - Bosch ICP-MAP5000-2 Installation Manual

46 en | Connections
Connecting the power supply
Connection Description
1
2
3
4
5
6
7
8
9
10
3.5

Connecting the LSN gateway

Notice!
When connecting an LSN component, ensure that you follow local standards and guidelines
when planning the system installation.
The following applies for VdS systems: Each area must be supplied with power
independently. The outputs AUX1 and AUX2 on the LSN gateway (for max. two areas) or the
voltage outputs of the fuse plate (SIV) (for additional areas) are available for this purpose.
2016.06 | 17 | F.01U.168.332
1 1
2 2
Battery circuit 2
Battery circuit 1
Connection for thermistor
Power connection to main panel
Input for tamper switch, is activated by configuration for remote operation of
the power supply on the external BDB.
Output for voltage supply (switched), supervised, nominal voltage 24 V DC
Data bus - connection A
Data bus - connection B
Output for AC fail and summary power supply trouble (optional)
AC connection
Installation manual
MAP 5000
Bosch Sicherheitssysteme GmbH