Configuring Access-Groups - Cisco ASR 9000 Series Configuration Manual

Configuring access-groups

Command or Action
Step 4
group limit range
Example:
RP/0/RSP0/CPU0:router(config-igmp-snooping-profile)#
group limit 100
Step 5
commit
Configuring access-groups
This task instructs IGMP Snoop to apply the specified access-list filter(s) to receive membership reports.
The user needs to create and configure access-lists before configuring the access-groups. For detailed
configuration procedures, for creating and configuring standard and extended access-lists, refer to the Cisco
ASR 9000 Series Aggregation Services Router IP Addresses and Services Configuration Guide.
SUMMARY STEPS
1. configure
2. igmp snooping profile profile-name
3. access-group acl-name
4. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
igmp snooping profile profile-name
Example:
RP/0/RSP0/CPU0:router(config)# igmp snooping profile
name1
Step 3
access-group acl-name
Example:
RP/0/RSP0/CPU0:router(config-igmp-snooping-profile)#
access-group acl1
Step 4
commit
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
36
Implementing Layer-2 Multicast with IGMP Snooping
Purpose
Limits the number of groups (or source-groups)
allowed on a port.
Purpose
Enters IGMP snooping profile configuration
mode and creates a new profile or accesses an
existing profile.
Configures group membership filter(s).