Install And Upgrade Internal Modules And Field Replaceable Units; Access Internal Modules - Cisco C11 1 8P Series Hardware Installation Manual

Install and Upgrade Internal Modules and Field
Replaceable Units
The Cisco 1100 Series Integrated Services Routers have internal modules and field-replaceable units (FRUs)
that can be quickly and easily removed and replaced without having to send the entire router for repair.
This section describes how to install and upgrade the internal modules and FRUs in the Cisco 1100 Series
ISRs. The information is contained in the following sections:
•
•
•
•

Access Internal Modules

To access the internal modules on the router, you must first disconnect the power source and then remove the
chassis cover. See the Replacing the Chassis Cover section for instructions on how to remove and later
replace the chassis cover on the routers.
Warning Only trained and qualified personnel should be allowed to install, replace or service this equipment. Statement
1030.
Warning
Before opening the unit, disconnect the telephone-network cables to avoid contact with telephone-network
voltages. Statement 1041.
Warning
Power off the unit before you begin. Statement 237.
Access Internal Modules, on page 55
Locate Internal and External Slots for Modules, on page 57
Install an LTE Pluggable Module, on page 57
Install and Remove Small Form Pluggable Modules, on page 64
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
4
C H A P T E R
55