Configuring The Mldp User Interface For Feature Filtering - Make-Before-Break - Cisco ASR 9000 Series Configuration Manual

Multipoint Label Distribution Protocol Route Policy Map
Command or Action
Step 6
Use the show command to verify the configuration:
show running-config mpls ldp mldp
An example output showing the mLDP MoFRR output
RP/0/1/CPU0:GSR3#sh mpls mldp database opaquetype ipv4
mLDP database
LSM-ID: 0x00019
FEC Root
Opaque decoded
Features
Upstream neighbor(s) :
Downstream

Configuring the mLDP User Interface for Feature Filtering - Make-before-break

SUMMARY STEPS
1. configure
2. mpls ldp mldp
3. address-family ipv4
4. make-before-break route-policy mldp_policy
5. end
6. commit
7. Use the show command to verify the configuration: show running-config mpls ldp mldp
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
172
Type: P2MP
: 10.0.0.1
: [ipv4 0.0.0.0 224.1.1.1]
: MoFRR
10.0.0.1:0 [Active]
Next Hop : 10.0.3.3
Interface : GigabitEthernet0/2/1/1
Local Label (D) : 16028
client(s):
LDP 10.0.0.2:0 Uptime: 03:25:15
Next Hop : 10.0.4.2
Interface : GigabitEthernet0/2/1/2
Remote label (D) : 16029
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
An example output is as shown:
Wed Jun 25 12:46:52.177 IST
mpls ldp
mldp
address-family ipv4
make-before-break delay 0
mofrr route-policy mldp_policy
neighbor route-policy mldp_policy out
neighbor 1.1.1.1 route-policy mldp_policy in
neighbor 1.1.1.1 route-policy mldp_policy out
neighbor 2.2.2.2 route-policy mldp_policy out
recursive-fec route-policy mldp_policy
!
!
!
Uptime: 03:25:15
Uptime: 03:25:15