Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Configuring Multicast Hub and Spoke Topology: Example
These examples describe two ways to configure Multicast Hub and Spoke:
Figure 21: Example for CE1 PE1PE3 CE3Multicast Hub and Spoke Topology
CE1------------------ PE1 ------------------------------------------------ PE3 ------------------ CE3
CE1, PE1, and PE3 are all on Cisco IOS XR Software, CE3 has Cisco IOS Software in order to configure
autorp on VRF interface. For information about configuring the CE router, using Cisco IOS software, see the
appropriate Cisco IOS software documentation.
Hub and Spoke Non-Turnaround Configuration: Example
A1-Hub-1 (bsr RP) A1-Hub-4 (auto-rp RP)
A1-Spoke-3
No turnaround case with bsr and autorp relay
PE1:
vrf A1-Hub-1
address-family ipv4 unicast
import route-target
1000:10
1001:10
!
export route-target
1000:10
!
!
vrf A1-Hub-Tunnel
address-family ipv4 unicast
import route-target
1000:10
!
!
!
vrf A1-Spoke-Tunnel
address-family ipv4 unicast
import route-target
1001:10
!
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
Configuring Multicast Hub and Spoke Topology: Example
281