Configuring VRF for MSDP
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
router msdp
Example:
RP/0/RSP0/CPU0:router(config)# router msdp
Step 3
peer peer-address
Example:
RP/0/RSP0/CPU0:router(config-msdp)# peer 10.0.5.4
Step 4
password {clear | encrypted} password
Example:
RP/0/RSP0/CPU0:router(config-msdp-peer)# password
encrypted a34bi5m
Step 5
commit
Step 6
show mfib [vrf vrf-name] [ipv4 | ipv6] hardware route {* |
source-address | group-address[/prefix-length]} location node-id
Example:
RP/0/RSP0/CPU0:router# show mfib hardware route * location
0/1/cpu0
Configuring VRF for MSDP
Use the vrf keyword in the MSDP configuration mode to enable VRF for MSDP.
SUMMARY STEPS
1. configure
2. router msdp
3. vrf vrf-name
4. peer peer-address
5. commit
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
232
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
Enters MSDP configuration mode.
Configures the MSDP peer.
Configures the password.
Displays multicast routes configured with
multicast QoS and the associated
parameters.