Lsp-Switch For P2Mp-Te; Configuration Process For Mldp Mvpn (Intranet) - Cisco ASR 9000 Series Configuration Manual

Label Switched Multicast (LSM) Multicast Label Distribution Protocol (mLDP) based Multicast VPN (mVPN) Support
Profile
Number
5
6
7
8
9

LSP-switch for P2MP-TE

Turnaround for P2MP-TE can be handled by LSP-switch with a partitioned profile. For partitioned profiles,
there is no core tree (where all the PEs join). When the traffic arrives at the ingress PE, it is forwarded to the
RP-PE on a LSP. The RP-PE must then switch the traffic to a different LSP for all the non-RP PE receivers.

Configuration Process for MLDP MVPN (Intranet)

These steps provide a broad outline of the different configuration process of MLDP MVPN for intranet:
Note For detailed summary of the various MVPN profiles, see the
page 117.
• Enabling MPLS MLDP
• Configuring a VRF entry
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
118
Name Opaque-value
MS- PMSI (Partition) Type 1 - Source-
MLDP P2MP with PE:Global -ID
BGP -AD
VRF Inband MLDP RD:S,G
Global Inband S,G
Global P2MP TE N/A
Rosen MLDP with Type 2 -
BGP -AD RootAddresss:VPN -
ID:0 -n
◦ configure
◦ mpls ldp mldp
◦ configure
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
BGP-AD
• I- PMSI with
empty PTA
• MS- PMSI for
partition mdt
• S- PMSI for
data-mdt
• S- PMSI cust
RP-discovery trees
N/A
N/A
N/A
• Intra-AS MI- PMSI
• S- PMSI for
Data-MDT
Summary of Supported MVPN Profiles, on
Data-MDT
BGP-AD
N/A
N/A
N/A
PIM or BGP-AD
(knob controlled)