Configuring Group Limits; Configuring Route-Policy - Cisco ASR 9000 Series Configuration Manual

Configuring Group Limits

Command or Action
Step 2
show l2vpn forwarding bridge-domain
[bridge-group-name:bridge-domain-name] mroute ipv4
[detail] [hardware {ingress | egress}] location node-id
Example:
RP/0/RSP0/CPU0:router# show l2vpn forwarding
bridge-domain bridgeGroup1:ABC mroute ipv4 detail
location 0/3/CPU0
Step 3 show l2vpn forwarding bridge-domain
[bridge-group-name:bridge-domain-name] mroute ipv4
summary location node-id
Example:
RP/0/RSP0/CPU0:router# show l2vpn forwarding
bridge-domain bridgeGroup1:ABC mroute ipv4 summary
location 0/3/CPU0
Configuring Group Limits
This procedure consists the following tasks:

Configuring route-policy

SUMMARY STEPS
1. configure
2. route-policy policy-name
3. end-policy
4. commit
DETAILED STEPS
Command or Action
Step 1 configure
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
34
Implementing Layer-2 Multicast with IGMP Snooping
Purpose
Displays multicast routes as they are converted into the
forwarding plane forwarding tables. Use optional arguments
to limit the display to specific bridge groups or bridge
domains.
If these routes are not as expected, check the control plane
configuration and correct the corresponding IGMP snooping
profiles.
Displays summary-level information about multicast routes
as stored in the forwarding plane forwarding tables. Use
optional arguments to limit the display to specific bridge
domains.
Purpose