Configuring Head Pe Router (For Mofrr) - Cisco ASR 9000 Series Configuration Manual

Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Command or Action
Step 6
mofrr acl-name
Example:
RP/0/RSP0/CPU0:router(pim)# mofrr flow_mofrr
Step 7
commit
Step 8 show mfib hardware route summary location
Example:
RP/0/RSP0/CPU0:router#
4

Configuring Head PE Router (for MoFRR)

Pre-requisites
• ACL configurations. (for detailed information on how to configure ACLs, refer the Configuring ACLs
The head PE router can be configured as follows:
SUMMARY STEPS
1. configure
2. router pim [address-family ipv4]
3. mofrr
4. mofrr acl-name
5. clone source S to S1 S2masklenn
6. commit
7. show pim topology route
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 router pim [address-family ipv4]
Example:
RP/0/RSP0/CPU0:router(config)# router pim
show mfib hardware route
chapter of the IP Addresses and Services configuration guide.)
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
Purpose
Enables MoFRR for the specified access list source
group with hardware switchover triggers. This is
supported on IPv4 only.
Displays the number of enabled MoFRR routes.
Purpose
Enters PIM configuration mode, or PIM address-family
configuration submode.
Configuring MoFRR
237