Configuring Mldp Fec At The Root Node; Configuring The Mldp Fec At The Root Node Using The Route Policy - Cisco ASR 9000 Series Configuration Manual

Multipoint Label Distribution Protocol Route Policy Map
Command or Action
Step 5
end-policy
Example:
RP/0/RSP0/CPU0:router(config-rpl)# end-policy
Step 6 commit
Step 7
Use the show command to verify the configuration: show
running-config route-policy mldp_policy

Configuring mLDP FEC at the Root Node

Perform this task to configure mLDP FEC at the root node using the route policy to filter Label Mappings
and selectively apply the configuration features. Currently, mLDP FEC is configured to filter at the IPV4 root
node address along with the mLDP opaque types.

Configuring the mLDP FEC at the Root Node Using the Route Policy

SUMMARY STEPS
1. configure
2. route-policy mldp_policy
3. if mldp root
4. end-policy
5. commit
6. Use the show command to verify the configuration: show running-config route-policy mldp_policy
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 6.0.x
168
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Purpose
An example output is as shown:
Sun Jun 22 20:03:34.308 IST
route-policy mldp_policy
if mldp opaque vpnv6 2:2 10::1 ff05::1 then
pass
endif
end-policy
!
Purpose
Enters global configuration mode.